CompTIA 220-602 Exam Description
After passing the A+ IT Technician test, you can work as an IT Technician, Enterprise Technician, PC Technician, Desktop Support Technician, Field Technician or PC Support Specialist. If you would like to know more about the A+ IT Technician test 220-602 please visit the CompTIA Website.

The A+ IT Technician test validates your skills and knowledge on different types of hardware and operating systems, basic networking as well as soft skills and office communication. 220-602 is a vendor neutral entry-level test, which can be used for the preparation of many-advanced certification such as MCSE, CCNA etc.

IT Technician exam is designed to measure your ability to support computers and install, configure, troubleshoot, optimize, diagnose and perform preventive maintenance in the field or in organizations. 220-602 test is an elective for the A+ certification. You now have to pass two exams to achieve the new A+ certification. The A+ Essentials is the mandatory exam and the other two electives are A Remote Technician and A+ Depot technician.

Exam : CompTIA 220-602
Title : CompTIA A+ 220-602 (2007 Edition) IT Technician Exam
1. Which of the following should a technician do FIRST to troubleshoot a users network connectivity problem?
A. Run TRACERT from the users workstation.
B. Start with the Last Known Good Configuration and reboot the computer.
C. Replace the network interface card (NIC).
D. PING the users workstation.
Answer: D

2. Making data appear to come from somewhere other than the originating point is known as:
A. social engineering.
B. spoofing.
C. hacking.
D. cracking.
Answer: B

3. A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem?
A. Windows cannot be booted from a controller card.
B. The hard drive must have Windows reinstalled because a new controller card was installed.
C. The SATA controller card was not set as a boot device in the computer BIOS.
D. The new controller must have the correct jumper settings for Windows mode.
Answer: C

Most of our study materials for your CompTIA 220-602 exam is exclusively prepared by the best 220-602 braindumps from the IT domain to ensure 100% pass percentage in your CompTIA 220-602 Exam.

Testinside known to be the best for providing the 220-602 exam questions for the CompTIA 220-602 certification and training. Our 220-602 expert's team has designed and prepared the training kit for CompTIA 220-602 certification. It's designed to be relevant in today's rapidly changing IT marketplace, Testinside CompTIA 220-602 study guide help you utilize evolving technologies, enhance your troubleshooting skills, and improve your job satisfaction.

Most of our study materials for your CompTIA 220-602 exam is exclusively prepared by the best 220-602 braindumps from the IT domain to ensure 100% pass percentage in your CompTIA 220-602 Exam.